|S P E C I F I C A T
I O N S
||Up to 4 hours
MS 1073:Part 2:1993;SS 332:1988.
MS 1073:Part 3:1996.
40-50mm thick door-leaves formed from 2.0 mm electrogalvanised (zinc-coated) steel
skins reinforced with internal C-profiled through-going stiffeners welded to the outer
skins, insulated with glass-wool, complete with preparation for locks, reinforcement
plates for overhead door-closer, fixed, recessed hinge pockets, inverted "U"
Frames are formed from 1.0 - 1.5 mm electrogalvanised (zinc-coated) steel, seam
welded, recessed head-jamb, complete with mortar boxes and preparations for hinge,
door-closer and strike. Standard Single and Double Rebate profiles F1 & F2.
Primer coat only unless otherwise specified.
Hardware preparations are provided as standard for 2-4 hinges, one door-closer and
mortise or cylinder lockset. Additional hardware preparations will attract additional
Unequal, door leaves. "h" - profile astragal (detail A1). Additional hardware
preparations include flush-bolt provisions for idle side, additional door closer
||900 x 2,000 mm
Leaf~23 - 26kg/m2
( depending on infill )
Frame Size, Width x Height (in mm)
Single Leaf - 1,400 x 2,600 mm
Double Leaf - 2,600 x 2,600 mm
||Up to Rw ~ 34 dB
with (optional) acoustic frame system and special hardware.
||In excess of
100,000 open and slam-shut cycles.
40 ~ 50mm door thickness. 1.2 ~ 2.0 mm galvanised steel, 1.0 ~ 2.0 mm stainless
steel door, 0.7 mm PVC laminated steel skins. Adjustable hinge pockets.
1.2 ~ 2.0 mm galvanised or stainless steel frames; seals; stainless steel striker
plate for lock; preparation for electric strike or sensor; knock-down construction;
semi-airlight profiles F3 & F4.
Customised profiles in stainless steel or electrogalvanised steel, S1, S2, S3.
Formica laminate on one or both sides.
Factory finished final paint coat is not recommended because of the risk of damage
during transit, storage and fixing.
Vision panels and most hardware, including, panic devices, floor springs,
eye-viewers, pivot hinges, door-chains, concealed door-closers, kick and push plates, push
and pull handles, electrical hold-open devices, etc.
| Main | Specifications | Drawings